Components
Microwave Removal and Component Access
Note: Some components can be accessed without removing the microwave. If the 2 end screws on top of the outer cover are accessible (see illustration below), the hidden vent can be removed without removing the microwave from its installation.
Note: For easier removal and personal safety, it is recommended that 2 people remove the microwave.
Unplug the microwave and remove it from the wall by removing three screws in the cabinet above the microwave.
Tilt the microwave forward and lift it off the lower tabs of the rear mounting plate. Route the power cord through the hole.
Exhaust Fan
Resistance through the exhaust fan from the power cord (N) to CN03 pin 7 is approximately 28.7 ohms.
Removal
Remove the microwave (see Microwave Removal and Component Access). Remove the screw on top of the microwave holding the exhaust adapter in place, then slide the exhaust adapter to the rear and remove.
Top View
Remove the screw holding the fan in place.
Lift the fan out of the microwave and disconnect the electrical connector.
Place the microwave on a protected counter or table.
To remove the cover, remove 2 screws from the left side, 3 screws from the right side, 5 screws
from the top, 5 screws from the rear, and 2
Disconnect screws from the bottom of the outer cover.
Open the microwave oven door. Slide the hidden vent to the left and remove the hidden vent.
– 9 –
