Instructions
Installation of the range.
TOOLS YOU WILL NEED
Operating Instructions Safety
■Phillips and
■Pencil and ruler
■Two pipe wrenches (one for backup)
■
■Nut driver or wrench: 1/4 ″
■Drill
ADDITIONAL MATERIALS YOU MAY NEED:
■Gas line
■Pipe joint sealant or
*Teflon: Registered trademark of DuPont
■Flexible metal appliance connector (1/2 ″ I.D.). A
■Flare union adapter for connection to gas supply line (3/4 ″ or 1/2 ″ NPT x 1/2 ″ I.D.)
■Flare union adapter for connection to pressure regulator on range (1/2 ″ NPT x 1/2 ″ I.D.)
■Liquid leak detector or soapy water.
■Lag bolt or 1/2 ″ O.D. Sleeve anchor (for concrete floors only).
■Squeeze Connector matching the size of the bracket opening (on the range back behind the wiring cover) and the house conduit. Obtain only if replacing the power cord with conduit.
Installation | Instructions |
LOCATION GUIDELINES
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.
Troubleshooting Tips
Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting. Use care when moving the range on this type of flooring. It is recommended that the following simple and inexpensive instructions be followed to protect your floor.
The range should be installed on a sheet of plywood (or similar material). When the floor covering ends at the front of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering.
This will allow the range to be moved for cleaning or servicing. Also, make sure your floor covering will withstand 180°F. (See the Installation Safety Instructions section.)
Make sure the wall coverings around your range can withstand the heat generated (up to 200°F) by the range. (See the Installation Safety Instructions section.)
Consumer Support
IMPORTANT!
Remove all tape and packaging. Make sure the burners are properly seated and level. Take the accessory pack out of the oven.
Check to be sure that no range parts have come loose during shipping.
42
