GE P2B918 Seal the Openings, Assemble Surface Burners, Check Ignition of Surface Burners, Caps

Safety Instructions

Installation of the range.

Seal the Openings

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

Instructions

Assemble Surface Burners

Burner Heads (on some models)

Place burner heads over the electrodes on the cooktop, in the correct locations according to their size. There is one small, one

Caps

Place the matching size caps onto the burner bases or heads.

Operating

medium, one large and one extra large burner head.

Medium head Small head

Medium cap

Large cap

Small cap

	Extra large
Front of range	cap

Large head		Extra large
	Front of range
		head

Make sure that the heads and caps are replaced in the correct locations.

Installation Instructions

Troubleshooting Tips

Make sure the slot in the burner head is positioned over the electrode.

Electrode Slot

Oval (Center) Burner Head/Cap Assembly

Place the oval (center) head/cap assembly over the electrode on the cooktop.

Oval head and cap	Make sure the slot in
	the burner head is
assembly
	positioned over the
	electrode.

Grates

Place the left, right and center grates on the cooktop. These grates are position specific. The undersides of the left and right grates are marked “LEFT FRONT” and “RIGHT FRONT.” Place the middle grate with its bowed front toward the front of the range.

Left Front Center Right Front

CAUTION:Do not operate the burner without all burner parts in place.

Slot

Front of range Electrode

Consumer Support

Check Ignition of Surface Burners

Operation of all cooktop burners should be checked after the range and gas supply lines have been carefully checked for leaks.

50

Electric Ignition

Select a top burner knob and simultaneously push in and turn to LITE position. You will hear a clicking sound indicating proper operation of the spark module. Once the air has been purged from the supply lines, burners should light within 4 seconds. After burner lights, rotate knob out of the LITE position. Try each burner in succession until all burners have been checked.