GE P2B918 Install the Anti-Tip Device, When All Hookups Are Completed, Installation of the range

Instructions

Installation of the range.

Operating Instructions Safety

Install the Anti-Tip Device

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include

all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket Wall plate

Screw must

enter wood

or metal

Typical installation of anti-tip bracket attachment to wall.

WARNING:

■Range must be secured by Anti-Tip bracket supplied.

■If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Installation Instructions

Consumer Support Troubleshooting Tips

When All Hookups Are Completed:

MAKE SURE ALL CONTROLS ARE LEFT IN THE	MAKE SURE THE FLOW OF COMBUSTION
OFF POSITION.	AND VENTILATION AIR TO THE RANGE IS
	UNOBSTRUCTED.

Converting to LP Gas (or converting back to natural gas from LP)

This range leaves the factory set for use with natural	The conversion instructions and LP orifices can be
gas. If you want to convert to LP gas, the conversion	found attached to the range next to the pressure
must be performed by a qualified LP gas installer.	regulator.
	Keep these instructions and the orifices in case you
	want to convert back to natural gas.

52