GE PDE9900 Dishwasher Components, Door Panel PDW9700 Series and PDW9900 Series, PDW8900 Series

Dishwasher Components

Door Panel

PDW9700 Series and PDW9900 Series

Note: For top control dishwashers, there must be

1/2-inch clearance between the top of the door and the counter top.

The door panel covers the main control board, detergent cup, vent fan, motor, louver, wire harness, Smart Dispense bottle, Smart Dispense detergent sensor, Smart Dispense pump, and door-interlock switch.

The outer door panel is held in place by 12 screws (5 Phillips head screws per side and two 1/4-in. hex head screws at the bottom).

Note: A ribbon cable connects the keypad membrane (3-digit display on some models) to the control circuit board. Due to the ribbon length, care must be taken when removing the door panel to ensure that the ribbon cable is not damaged.

PDW8900 Series

The door panel covers the main control board, detergent cup, wire harness, Smart Dispense bottle, Smart Dispense detergent sensor, and Smart Dispense pump.

Escutcheon Keypad

Assembly Screws

The outer door panel is held in place by 12 screws (5 Phillips head screws per side and two 1/4-in. hex head screws at the bottom). The esutcheon keypad is held on by 4 screws.

Note: When removing the outer door panel, be careful not to remove the 4 screws (2 per side) holding the escutcheon to the door assembly.

Remove these only to gain access to the control module, active vent, flapper, and door interlock switch.

– 12 –