4Enhancements
The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.
DELAY HOURS You can delay the start of a wash cycle for up to 24 hours (depending on model). Press the DELAY START pad to choose the number of hours you want to delay the start of the cycle; then press START/RESET.
|
|
| After closing the door, the machine will count down and automatically start at the correct time. |
|
|
| NOTE: To cancel the DELAY START selection before the cycle begins, press the DELAY START |
|
|
| pad until the display shows the estimated cycle time for the selected cycle in minutes. |
|
|
|
|
|
| ADDED HEAT | When selected, the cycle will run longer with heating element on to improve both wash and dry |
|
| ||
(EXTRA HOT WASH) | performance. | ||
|
|
| NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
|
|
|
| PRE WASH | For use with heavily soiled and/or |
|
| (on some models) | starting the cycle. This option adds 15 minutes to the cycle time. |
|
|
| NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
|
|
|
| HEATED DRY | Shuts off the drying heat option. Dishes will air dry naturally (PDW8900 Series) or |
|
| Light Off | fan dry (PDW9700 and PDW9900 Series) to save energy. |
|
|
|
|
|
| HEATED DRY | Turns the heating element on for fast drying. This will extend the total cycle time by 15 minutes for |
|
|
| the |
|
|
| 30 minutes for the CHINA CRYSTAL cycle, and 38 minutes for all other cycles. |
|
|
| NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
|
|
|
| LOCK | You can lock the controls to prevent any selections from being made. Or you can lock the controls |
|
|
| after you have started a cycle. |
|
|
| Children cannot accidentally start dishwasher by touching pads with this option selected. |
|
|
| To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds. To lock the |
|
|
| dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light above the LOCK pad |
|
|
| will turn off. |
|
|
|
|
|
| RESET | To change a cycle after washing starts… |
|
|
| PDW8900 Series: Touch the START/RESET pad to cancel the cycle. The START/RESET light will |
|
|
| flash while the water is pumped out if needed. This takes approximately 2 minutes. |
|
|
| PDW9700 and PDW9900 Series: Open the door slowly to prevent |
|
|
| START/RESET pad to cancel the cycle. If the START/RESET light is flashing, close the door |
|
|
| until the water pumps out (this takes approximately 2 minutes) and the light stops flashing. |
|
|
| When the light stops flashing, the dishwasher can be reprogrammed and restarted. |
– 8 –
