Installation Instructions
4 CONNECT POWER
Plug power cord into properly grounded receptacle.
5INSTALL FILTERS, CHECK OPERATION
•Press and hold the ON/OFF pad on the control to raise the vent.
•Slip fingers into the vent holes. Lift the vent straight up and then down.
•Slide filter into the retainers and close the vent.
•Press the Fan Speed HIGHER pad to start the blower. Adjust the blower by pressing HIGHER or LOWER. The blower, if left on, will automatically turn off when the vent is lowered.
Filter Tabs
NOTE: It is not necessary to turn the fan OFF before lowering the vent. The fan will automatically turn off when the vent is lowered. When the fan is not turned off before lowering the vent, it will automatically come on at the previously set speed when the vent is fully raised.
To lower the vent, press the ON/OFF pad.
IMPORTANT: The vent can be activated by pressing the pads on the switch. Do not use excessive force or sharp objects to activate the switch. Damage could occur and void the warranty.
CLEANING
Painted or Stainless Steel Surfaces
To clean the stainless steel or painted surfaces, use warm, sudsy water or a stainless steel cleaner or polish.
The filters should be washed by hand. Do not clean filters in the dishwasher.
13
