Installation Preparation

REMOVE PACKAGING FROM BUILT-IN MODELS

1.Cut the banding. Use a box cutter or utility knife

to score and cut the carton along the base (or remove the staples with a staple remover or a screwdriver).

2.Lift the carton straight up and off of the grill.

Cut the banding with tin snips.

Score and cut.

3.Remove all outside packing materials.

4.Remove the screws from the hold-down boards on the skid. This will allow better access to the ends when lifting the grill off the skid.

6.Close the lid. Cut the plastic tie holding the wires against the left side. Let the battery and transformer wires hang loose along the back side.

Cut tie on the rear vertical support.

7.Lift the grill off the skid and slide it into the prepared countertop opening.

8.Remove the tie holding the sear burner (on some models). Lift the wire mesh cover on the sear burner and remove packaging. Carefully, replace the wire mesh cover. The wire mesh must be wrapped around the vertical side flanges of the burner.

Lift wire mesh and

remove packaging.

Hold-Down

Boards

5. Open the lid. Cut plastic ties and bands. Remove the parts package. Remove the grill grates and packaging.

Replace wire mesh cover.

15