GE ZSC1000, ZSC1001 Questions? Use this problem solver, Troubleshooting, Lights, Cooking, Problem

Questions?

Use this problem solver

Troubleshooting

Advantium Oven

Problem	Possible Causes	What To Do/Explanation
LIGHTS
Light during a	This is normal.	• This is normal. The oven senses the
speedcook cycle	Power level has been	heat level and adjusts automatically.
dims and cycles on	automatically reduced
and off, even at full	because the oven is hot.
power levels
Light visible around	This is normal.	• When the oven is on, light may
the door and outer		be visible around the door and
case while		outer case.
speedcooking
FAN
Fan continues to run	The oven is cooling.	• The fan will automatically shut off
after cooking stops		when the internal parts of the oven
		have cooled.
Oven vent emits warm This is normal.
air while oven is on
Fan comes on	This is normal.
automatically when
using the microwave
COOKING
The oven makes	Clicks and fans blowing	• These sounds are normal.
unusual sounds	are normal. The relay
while cooking	board is turning the
	components on and off.
Smoke comes out	Food is high in fat	• Smoke is normal when cooking
of the oven when	content. Aerosol spray	high-fat foods.
I open the door	used on the pans.
Food is not fully	Programmed times	• Increase or decrease time for
cooked or browned	may not match the size	doneness or adjust the upper or
at the end of a	or amount of food you	lower lamps for browning and
cooking program	are cooking.	doneness.
SENSOR ERROR	Food amount or type	• Press the CLEAR/OFF pad. Set the
displayed along with	placed in the oven does	oven program to match the food or
an oven signal	not match the program	liquid to be cooked or heated.
	that was set.
	Steam was not sensed by • Vent plastic wrap, use a looser lid
	the oven because plastic	or uncover liquids when cooking or
	wrap was not vented, a lid	heating.
	too tight was on the dish
	or a liquid was covered.

39