Installation Instructions
2ROUTE CONDUIT THROUGH CUTOUT
CAUTION: Two people are required to lift the oven into the opening. Grasp the bottom at front and rear. Discard foam base. DO NOT USE HANDLE OR CONDUIT TO LIFT THE OVEN. DAMAGE WILL OCCUR.
With oven in front of the cabinet opening:
•Insert conduit into cabinet opening. Connect oven wiring and branch circuit.
•Lift the oven into the opening while continuing to feed the conduit in the direction of the installed junction box. Be sure the conduit does not get pinched between the back of the oven and the cabinet wall.
•Leave oven a few inches forward of the cabinet front frame. Do not push the unit all of the way into the cutout.
(Oven shown without accessory storage drawer.)
WARNING
•Disconnect power to the junction box before making the electrical connection.
•Electrical ground is required on this appliance.
•Do not connect the electrical supply until appliance is permanently grounded.
GROUNDING INSTRUCTIONS
This appliance must be connected to a grounded, metallic, permanent wiring system, or an equipment grounding connector should be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance. Failure to follow these instructions could result in fire, personal injury or electrical shock.
10
2ROUTE CONDUIT THROUGH CUTOUT (CONT.)
When connecting to a 3-conductor branch circuit:
•Connect oven red lead to branch circuit red lead.
•Connect oven black lead to branch circuit black lead.
•Connect oven green ground lead and white lead to branch circuit neutral (white or gray).
When connecting to a 4-conductor branch circuit:
•Connect oven red lead to branch circuit red lead.
•Connect oven black lead to branch circuit black lead.
•Break connection between oven white lead and oven green ground lead.
•Connect oven white lead to branch circuit neutral lead (white or gray).
•Connect oven green ground lead to branch circuit ground lead (green or bare copper).