Installation Preparation
ELECTRICAL REQUIREMENTS
Single Speedcook Installation
Product rating is 120/208 or 120/240 volt, 60 Hz,
30 amps. This product must be connected to a supply circuit of the proper voltage and frequency and protected by a time delay fuse or circuit breaker. Power should be supplied from a separate, dedicated
Combined Speedcook and Wall Oven Installation
When installed in combination with a GE/Monogram single wall oven, use separate electrical junction boxes.
Refer to single oven installation instructions for electrical requirements of that product.
These connections must be made by a qualified electrician. All electrical connections must meet National Electrical Code or prevailing local codes.
Combined Speedcook and Warming Drawer Installation
When installing the Speedcook oven over a GE or Monogram electric warming drawer, a separate 120V, 60Hz, properly grounded receptacle must be installed. See instructions packed with the warming drawer.
WARNING
•The electrical power to the oven branch circuit must be shut off while line connections are being made.
•Use copper wiring only.
•Electrical ground is required on this appliance. The free end of the green wire (ground wire) must be connected to a suitable ground.
This wire must remain grounded to the oven.
•If cold water pipe is interrupted by plastic,
•DO NOT ground to a gas pipe.
•DO NOT have a fuse in the NEUTRAL or GROUNDING circuit. A fuse in the NEUTRAL or GROUNDING circuit could result in an electrical shock.
•Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.
Failure to follow these instructions could result in serious injury or death.
INSTALL JUNCTION BOX
The conduit is located at the top right on the back of the oven.
Locate and install the junction box within reach of the oven conduit.
•Through the left or right sides of the cabinet wall and into adjacent cabinet.
•Or, through the cutout floor.
•Or, in the upper cabinet.
Cutout
Height
4
