GE ZSC2200, ZSC2201, ZSC2202 Installation over a GE/Monogram Oven, Installation Preparation

Installation Preparation

Preparation WITHOUT an Accessory Storage Drawer

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven:

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven and Warming Drawer:

30”23-1/2”

25-1/4”

Construct Solid Bottom Min. 3/8” Plywood Supported by 2x4 or 2x2 Runners all Four Sides

30”23-1/2”

25-1/4”

Construct Solid Bottom Min. 3/8” Plywood Supported by 2x4 or 2x2 Runners all Four Sides

17-1/2”	2” Min.
	(3” recommended)

Per Oven

Requirement

45-1/4”

Min.

•If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 240V and a single oven, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2” minimum shown.

17-1/2”	2” Min.
	(3” recommended)
	Per Oven
	Requirement
45-1/4”	2” Min.

Min.

Per warming drawer requirement

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details.

CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven, plus additional oven loads of up to 50 pounds or a total weight of 130 pounds.

6