Installation Preparation
Preparation WITHOUT an Accessory Storage Drawer
PREPARE THE OPENING
The Advantium 240V can be installed in combination with other GE/Monogram appliances. Always follow each product’s Installation
PREPARE THE OPENING (CONT.)
Installation over a GE/Monogram Warming Drawer:
Instructions to complete the installation.
Single Advantium 240V Installation:
Order a 30” wide single oven cabinet or cut the opening in a wall to the dimensions shown.
30”23-1/2”
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
| |||||
|
|
|
|
|
| Construct |
|
|
| ||||
|
|
|
|
|
| Base |
|
|
|
|
|
| Min. 3/8” |
|
|
|
|
|
| Plywood |
|
|
|
|
|
| Supported |
|
|
| ||||
|
|
|
| by 2x4 or 2x2 |
30”23-1/2”
Min.
Construct Solid Bottom Min. 3/8” Plywood Supported by 2x4 or 2x2 Runners all Four Sides
2” Min.
(3” recommended)
Per warming drawer requirement
Min. | Runners all |
| Four Sides |
•Always maintain
•Allow
•Oven overlaps will conceal cut edges on all sides of the opening.
When installed over a single oven or a warming drawer, allow at least 2” between the two openings. This separation will provide clearance for bottom overlap of the Advantium 240V and the other appliance overlaps.
Construct a solid oven floor of 3/8” min. thick plywood supported by 2 x 4 or 2 x 2 runners on all sides.
•The support must be level and rigidly mounted, flush with the bottom edge of the cutout.
NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details.
5