Installation Instructions
9SLIDE DUCT COVER DOWN, INSTALL SIDE UTILITY BARS
•Hold the decorative duct cover and remove the temporary stop screw from the support frame. Return the screw to the service manual envelope for future use.
•Slide the lower duct cover down onto the hood.
• Install the side utility bars with screws as shown.
10 INSTALL FILTERS
Upper Charcoal
Filter Slots
Lower Grease
Filter Slots
•There are two slots inside the back and front of the hood. These slots will hold the charcoal filters and stainless steel grease filters in place.
Install Charcoal Filters
Upper Charcoal
Filter Slots
Grasp Tab,
Lift and Pull Forward
•Remove protective film on charcoal filters.
•Tip charcoal filters into the upper (top) slots at the rear of the opening. Grasp the filter tab, lift and pull forward until it rests in the front slots.
•Install all 3 charcoal filters.
Install Grease Filters
Lower
Filter Slots
•Remove protective film from grease filters.
•Tip the grease filter into the lower slots at the rear of the opening. Lift the filter and pull the knob forward until the filter rests on the slots.
•Install all 3 grease filters.
•To remove the filters, grasp the knob, push the filter towards the rear and tilt downwards. Grasp tabs on charcoal filters, push towards the rear and tilt downwards.
11 FINALIZE INSTALLATION
•Remove the protective film covering the control panel on the front face of the hood, and any other packaging materials.
•Refer to the Owner’s Manual for operating instructions.
11
