GE Monogram ZXR858, ZXR859, ZXR8510 Install Hood, Connect Electrical, Installation Instructions

Installation Instructions

7 INSTALL HOOD

Align Duct			Bottom
Connector to	Align		Duct
			Cover
House Duct	Mounting
		Stop Screw
	Studs		Install
			4 lock
			washer
			and 4 Nuts

Note: TWO PEOPLE ARE REQUIRED TO COMPLETE THIS INSTALLATION!

•Lift the hood up to the support frame. Carefully align the hood mounting studs into the support frame holes, and at the same time, guide the hood duct connector into the duct.

•Install 4 nuts and lock washers. Tighten with a 10mm wrench.

•Check hood level in both directions.

•Check to be sure that the duct is positioned over the hood connector.

•Seal the duct connection with duct tape.

Note: Do not drive screws through this duct connection. Doing so will prevent proper damper operation.

8 CONNECT ELECTRICAL

Verify that power is turned off at the source.

WARNING: If house wiring is not 2-wire with a ground wire, a ground must be provided by the installer. When house wiring is aluminum, be sure to use UL approved anti-oxidant compound and aluminum-to-copper connectors.

•Install strain relief onto the knockout of the junction box cover.

•Insert house wiring through strain relief and tighten.

•Connect white leads to branch circuit white lead.

•Connect black leads to branch circuit black lead.

•Connect green/yellow leads to branch circuit green or bare ground lead.

•Secure all connections with wire nuts on each electrical connector.

•Push wires into junction box and replace cover. Be sure wires are not pinched.

10