Genesis Advanced Technologies GTS10S manuel dutilisation Maintenance, Non-Through Cutting

English

Non-Through Cutting

Non-through cutting are in cutting grooves, rabbets and dados. This is the only type of cut made with the blade guard assembly removed. You must make sure the entire blade guard assembly is reinstalled properly after completion of this type of cut.

Warning: Never feed work piece through with your hands when making non-through cut, such as rabbets or dados. Always use push stick and push block. Failure to do so can result in serious personal injury

Important: The table saw is a highly versatile tool, capable of a wide range of applications which cannot be covered in this manual. Do Not attempt to perform cuts not covered in this manual unless you are thoroughly familiar with procedures and featuring. Visit your local library for books on woodworking techniques.

MAINTENANCE

To Remove or Change the Blade

Warning:Always unplug the saw from power source before maintenance to avoid risk of serious personal injury.

To remove the blade:

1.Remove the two screws (1) holding the metal plate (2) in place, and remove the metal plate (FIG. 18)

2.Raise the blade to the highest possible position

3.To keep the arbor from rotating, place one of the open ended wrenches (4) on the flange flats (See FIG.19)

4.Place the second open ended wrench (3) on the arbor nut (See FIG 19)

5.Turn the second wrench (3) clockwise to tighten, counterclockwise to loosen. Loosen and remove the arbor nut (FIG. 19)

6.Remove the flange and pull of the blade off the motor shaft.

FIG. 18 FIG. 19

2 1 4 3

To install the blade, reverse the procedure.

Important: Blade rotation is counter-clockwise when seeing from the right side of the saw. Make sure the rotation direction mark on the blade matches with that.

Lubrication

This table saw are permanently lubricated at the factory and requires no additional lubrication.

10" Table Saw
Operator’s Manual	GTS10S