English
10" Table Saw
Operator’s Manual GTS10S
TrOUBLE SHOOTing
Problem Possible Cause Solution
Saw will not start 1. Saw is not plugged in 1.Plug to power source
2. Fuse blown or circuit breaker 2.Replace fuse or reset circuit break.
3. cord is damaged 3.Have power cord replaced by Authorized
4. Debris in ON/OFF switch 4.Clean any debris accumulated
Does not make accurate 45° 1.Positive stop not adjusted 1. Check the blade with square and adjust
2.Blade angle pointer not set
accurately
2.Check blade with square and adjust the
Blade angle pointer
Material Pinched Blade when 1.Rip fence not aligned with blade 1. Check and adjust the rip fence
2.Warped wood, edge against
fence is not straight
2.Select another piece of wood
Material Binds on Splitter 1. Splitter not in line correctly with
blade
1. Check and align the splitter with blade
Saw makes unsatisfactory 1.Dull Blade 1. Replace blade
2.Blade mounted backward 2. Turn blade around
3.Gum or resin on blade 3.Remove blade and clean
4.Incorrect blade for work 4. Change to correct blade
Material Kicked Back from the 1. Rip fence out of adjustment 1.Align rip fence with miter gauge groove.
2.Splitter not in line with blade 2.Align splitter with blade
3.Feeding stock without rip fence 3. Install and use rip fence
4.Dull blade 4. Replace blade
5.Bevel Knob is not tight 5.Tighten the knob
Blade does not raise or tilt
freely
1 Sawdust and dirt in
elevation/tilting mechanisms
1. Brush or blow out loose dust and dirt
Blade does not come up to 1. Extension cord is too light or too 1. Replace extension cord to adequate size
2. Low house voltage 2. Contact electrician
Saw vibrates excessively 1. Saw not mounted securely to 1.Tighten all mounting hardware
2. Bench or stand on uneven floor 2. Re-position on flat level floor
3. Damaged saw blade 3.Replace blade
TWO-YEAr WArrAnTY:
Thisproductiswarrantedfreefromdefectsinmaterialandworkmanshipfor2yearsafterdateofpurchase.Thislimitedwarrantydoesnotcover
normalwearandtearordamagefromneglectoraccident.Theoriginalpurchaseriscoveredbythiswarrantyanditisnottransferable.Pleasereturn
thetooltostorelocationofpurchasealongwithyourreceipt,andyouwillreceiveanewdrillorarefund.THIS PRODUCT IS NOT WARRANTED IF
USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
TOLL-FrEE HELP LinE:
ForquestionsaboutthisoranyotherGeNeSISProduct,pleasecallToll-Free:888-552-8665.
Orvisitourwebsite:www.richpowerinc.com