Genie 3531835447 installation instructions Electrical Warning

ELECTRICAL WARNING

Ensure there is No power to the Opener before installing Safe-T-Beam® System Wires. If Opener is plugged into outlet, Unplug it now.

NOTE

The Opener will not close the door automatically unless the Safe-T-Beam® System is installed.

A Install Safe-T-Beam ® Source and Sensor (Figure 25):
•	Mark both sides of garage door frame or wall 6"

Safe-T-Beam ® Sensor

(Green LED)

Safe-T-Beam ® Source

(Red LED)

Slidetongueontoof

Bracket until._. J it clicks into 4_//

place!/i}i

i:_1 Top of

_. Bracket 6"

I above

[floor

above floor.
Hold Bracket against door frame or wall. Check if Bracket
extends out from wall far enough so tongue of Bracket is
beyond door, tracks, or any door hardware. If not, Safe-T-
Beam ® Mounting Bracket Extensions are available from a
Genie Factory Authorized Dealer or through the
Accessories		Order Form.
-	Blocks	of wood, etc. may be substituted
	for extensions.

Position top of Mounting Bracket at 6" mark and fasten with 2 (#10-16 x 1-1/4") Phillips Hex Head Screws

per Bracket.

NOTE

Mounting Brackets can be attached to brick walls or concrete floor using masonry anchors (not included).

BAttach Safe-T-Beam ® Source (Red LED) and Sensor (Green LED) to Brackets (Figure 2S):

For single-door garages.

-Determine which side of garage receives the most direct sunlight, and place Source (Red LED) on this side whenever possible.

For multiple-door garages see (Figure 26).

-Preventing crossed signals is critical.

-Place Source and Sensor modules on adjacent doors facing in opposite directions.

NOTE

To help prevent interference from the sun, the Safe-T-Beam® Sensor (Green LED) may be placed further away from the door opening, where it will spend more time in the shadows.

•Slide the Safe-T-Beam ® Source and Sensor onto the tongues of the Brackets until they click into place.

•Check final height of Lens (Figure 27).

Figure 25 Install Safe-T-Beams ®

ONE DOOR	TWO DOOR
GARAGE	GARAGE

THREEDOOR

GARAGE

Figure 26 Source/sensor Locations

Top edge of Lens 5" - 6" above floor

Figure 27 Final Check Safe-T-Beams ®