Genie 3531835447 Seriousinjury or death, Are under extreme tension and can cause

This Opener includes parts and supplies needed to install in most garages and connect to most garage doors. There are many variations of garages and garage doors. A few additional parts and supplies may be needed to install Opener into your garage and connect to your garage door. While checking items listed below, note any additional items you will need.

TOol ued _ t_i ectio_s

• 12'+Tape Measure . Pencil . Ladder . Level

WARNING:

If your door sticks,binds,or is out of balance,have it adjusted by a Genie Factory Authorized Dealer. Door springs,cables, pulleys,bracketsand associatedhardware

are under extreme tension and can cause

seriousinjury or death.

NOTE

Check condition of vertical stile in center of door, and its connection to door's top and bottom beams.

AIf door frame is nailed together and not a solid connection, door frame must be braced or reinforced before installing Opener.

B If door is"lightweight"	(made with frame and skin -	not solid), door
(including door frame) must be braced or reinforced		before
installing Opener.

CA door opener reinforcement bracket may also be needed to connect garage door to Opener's Door Bracket. This Opener is designed for installation on a properly braced sectional door or solidly braced one-piece door.

DContact your Genie Factory Authorized Dealer or dealer of your garage door for any necessary bracing and a door opener reinforcement bracket (if needed) before proceeding.

EIf you have a wooden door, measure door's thickness. (1/4" x 2") Lag Screws are included for installing Door Bracket onto door. If your door is less than 2"thick, brace door or use shorter Door Bracket Lag Screws (1/4" x 11/4"- not included)

The Excelerator Opener is equipped with an automatic Garage Door Balance Detection System. SeeTroubleshooting Guide on page 27.

KEEP FEET CLEAR OF DOOR

Sectional Door

CHCK G£_£6 ©oo_

ALIGH _EIU I")OPEB£T 01%

ARaise door, check alignment and see if it moves freely (Figure 1). If door appears out of alignment, binds, or does not move smoothly, contact a Genie Factory Authorized Dealer or dealer of your garage door for repairs and adjustments to door mechanism.

Raise door to 3'- 4'above ground and carefully let go. Door should stay stationary. Slight movement is acceptable. More than slight movement means door is out of balance. Contact a Genie Factory Authorized Dealer

or dealer		of	your	garage door
for repairs		and adjustments			SECTIONAL ._cj_DOOR'TORSION		SPRINGS	SECTIONAL DOOR,
to door	mechanism.					I_ Torsion	Springs
C Check	door		type.	Make		_/_-_411-_.	"J
a note	of	whether		it is a	__	__-__,	_
sectional		or	a one-piece		__-	_:_'	-
door (Figure			2).			_........ e

One-Piece Door

Figure 1 Checking door balance

ONE-PIECE DOOR, TRACKLESS

EXTENSION SPRINGS

Header Area

.............::]--........+

_ Center Stile

Figure 2 Note Door Type