Genie 3531835447 installation instructions Appro112, Hardware red bag

CAUTION

;taples which are too tight may cut or pinch Wires. Cut or )inched Wires can cause the Safe-T-Beam® System to stop working. When installing the Insulated Staples, make sure _oufasten them only as tightly as needed to hold the Wire securely.

CInstall Safe-T-Beam ® Wiring (Figure 28):

•Route Wire and Insulated Staples (Figure 29 and Figure 30).

-Securely fasten Wires with Insulated Staples as you go. Staples should be snug only.

-Wires between garage wall and Power Head should be run on top of Rail and underneath Wire Clips.

Attach Wires to Safe-T-Beam ® Sensors.

-Split and strip Wire ends to be connected as shown.

-Loosen Terminal Screws.

-Insert each Wire under flat plate and tighten Screw. It does not matter which Wire, white or striped, goes on which Terminal.

•Attach Wires at Power Head.

-Wires are connected to Terminals #2 and #3 on Power Head Terminal Block. It does not matter which Wire, white or striped, goes on which Terminal.

Check the following.

-Ensure that no part of door or its hardware is in path between Source or Sensor Lenses.

•Ensure that tops of Lenses are between S" - 6" above floor. Brackets are flexible and can be adjusted slightly if needed.

NOTE

The Safe-T-Beam® alignment check will be performed following connection to electrical power.

Do Not plug in yet!

®		©
Insulated	Staples	#6-11/4"
(approximately	30 parts)	Pan Head Screws

Hardware (red bag)

Appro112

X,

Wire

@

Figure 28 Wire the Safe-T-Beam ® System

at Safe-T-Beam ® Leave slack for adjustment

Figure 29 Wiring Method A
Wire Clips (_	Insulated
	Staples
	@

Leave slack for

at Safe-T-Beam® J

STB j

i

Terminal attach ments at Power Head

Figure 30 Wiring Method A

adjustment