Genie 3531835447 Mounting Straps, Angle iron not included, Finished Ceilings

Check ceiling or space above where Opener Power Head will be mounted (Figure S):

AMeasure from garage door center line mark toward rear of garage:

•Approximately 10'back if garage has a 7'6" door.

•Approximately 11'back if garage has an 8'0" door.

•Approximately 13'back if garage hasan 10'0"door.

•Approximately 14'back if garage hasan 12'0"door.

NOTE

Mounting Straps are included to attach the Opener to most garage ceilings. Garage construction varies widely. Additional mounting straps or angle iron may be needed for your installation.

BFind location of ceiling joist or truss above where Opener Power Head will be and estimate type and quantity of materials needed for your installation (Figure 6).

OPEN BEAM CEILING EXAMPLES

Mounting Straps	Support board added
	for longer spans

	120 Volt	grounded	outlet
4_	or wiring	box within	3 feet of
°"f_	Power Head.

I IIIi "1 II

- - Door Center Line--

Figure S Check Power Head location

FINISHED CEILINGS

PerforatedLocate ceiling joists or

Angle Irontrusses using a stud finder or similar device.

Attach angle iron (not included) to joists or trusses through finish material using Lag Screws.

(Angle iron not included)

Figure 6 Mounting methods for open beam and finished ceilings

CtICK C iI.iI_16 l::_,._Fl'6FlOUl" _I[l [)

I OWER _,:;::'__:0JR_'=°'°. £

ACheck that there is a 1S Amp 120 Volt grounded electrical outlet or grounded permanent wiring box (per building code) within 3'of Opener Power Head:

•If not, an outlet or wiring box must be installed. Contact a licensed electrician for installation.

•If building codes require permanent wiring, Power Head must be partially disassembled to install appropriate wiring in place of Power Cord. See page 19

NOTE

Permanent wiring must be installed by a Licensed

Electrician. Not all Genie Factory Authorized Dealers are

Licensed Electricians. Contact someone who is a Licensed

Electrician.