Genie 3531835447 installation instructions Automatic Lighting System, Highspringtension

GarageDoorsareheavyobjectsthatmovewiththehelpofsprings Ifyouhavegaragedoorrelatedquestionsordonotunderstandthe underhightensionandelectricopeningequipmentSincemoving. informationpresented,callyournearestGenieFactoryAuthorized objects,springsundertension,andelectricopeningequipment Dealerlistedatwww.geniecompanyorcustomerServiceat.com, maycauseinjuries,yoursafetyandthesafetyofothersdependon 1-800-35-GENIE..youreadingandunderstandingtheinformationthismanual.

WARNING:

Can Cause Serious

Injury or Death

MOVINGDOOR

WARNING:

Can Cause Serious

Injury or Death

ELECTRICALSHOCK

WARNING:

Can Cause Serious

Injury or Death

HIGHSPRINGTENSION

o Keep people clear of opening while door is moving.

o Do Not allow children to play with the door operator.

o Do Not operate a door thatjams or one that has a broken spring.

oTurn off power before removing operator cover.

oWhen replacing cover, make sure wires are not pinched or near moving parts.

oOperator must be properly grounded.

oDo Not try to remove, repair or adjust springs or anythinqto which door sprinq parts are tastened, such as, woodl blocks, steel brackets, cables or other like items.

oRepairs and adjustments must be made by a trained service person using proper tools and instructions.

.& WARNING;

TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:

1READAND FOLLOW ALL SAFETY,INSTALLATIONAND OPERATIONINSTRUCTIONS.If you have any questions or do not understand an instruction, call your service representative.

2Do Not install operator on an improperly balanced door. An improperly balanced door could cause severe injury. Repairs and adjustments to cables, spring assembly, and other hardware must be made by a trained service person using proper tools and instructions.

3Remove all ropes, and disable all locks connected to the door before installing operator.

4Install door operator 7 feet or more above the floor.

Mount the emergency release knob 6 feet above the floor.

5Do Not connect the operator to the source of power until instructed to do so.

6Locatethe control button:

•Within sight of door.

•At a minimum height of 5 feet, so small children cannot reach it.

•Away from all moving parts of the door.

7Install the entrapment WARNING label next to the wall button or console. Install the emergency release tag on, or next to, the emergency release

8The operator must reverse when the door contacts a 1-1/2 inch high object on the floor at the center of

the doorway.This is about the size ofa 2"x 4" board laid flat.

Safe-T-Beam® (STB) Non-Contact Reversing System Places an invisible beam across door opening, that reverses the door during down travel to the fully open position if anything passes through beam.

Safe-T-Reverse ® Contact Reversing System Automatically stops and reverses a closing door within 2 seconds of contact with an object.

Safe-T-Stop ® Timed Reversed System

Automatically opens a closing door, if door does not close within 30 seconds.

Force Guard ® Control

Used to set the force required for opening and closing door. For maximum safety, set the minimum force required to fully open and close door.

Automatic Lighting System

Two light bulbs up to 60 Watts max. each, are used for safer entries and exits.The light turns on when door is activated and automatically turns off 4.5 minutes later.

Manual Emergency Release

Allows the garage door to be opened or closed manually for emergencies or maintenance.