Genie 3531835447 installation instructions @ Jfi, Hardware blue bag

COIl CT RAIL TO I ©WEF_

ATurn Power Head upside down and place on a flat level surface.

BInstall Bumper (Figure 9).

CInstall Coupler on Motor Shaft (Figure 9).

CAUTION

The Drive Screw and Rail Liner can slide out of Rail Sections.

Keep Rail Sections level until the Opener is fully assembled.

DConnect first Rail Section to Opener Power Head. Connect with 2 (1/4"-20) (yellow) Hex Head Shoulder Bolts and

2 (1/4"-20) Hex Serrated Flange Nuts (Figure 10). Finger-tightenuntil later.

EIf you have a 1-piece rail unit, skip Assembly Step 2.

AArrange arrows on Rail Sections to point in same direction and away from Power Head:

•Push Middle Drive Screw out about 2" toward Power Head,

•Slide Collar over Middle Drive Screw Hook (Figure 11A).

•Turn Middle Screw by hand to align Drive Screw Hooks between First and Middle Rail Sections.

•Latch two Hooks together and slide Collar over them (Figure 11B) and (Figure 11C).

•Snap Clip on Drive Screw next to Collar (Figure11D).

BAttach Middle Rail Section to First Rail Section, using 2 Rail Clamps, 4 (5/16"-18) Hex Shoulder Bolts, and 4 (5/16"-18) Hex Head Serrated Flange Nuts onto Bolts (Figure 11).

Finger-tighten until later. (Middle Rail Section looks the same on both ends. See page 8.)

CAttach End Rail Section to Middle Rail Section following procedures in step A & B.

RailStrap

S/16"-18HexHeadShoulderBolts

			@
			5/16"-18HexSerratedFlangeNuts
			@
	1/4"-20 Hex		1/4"-20HexHead	1/4"-20Hex
RailClamps	SerratedFlangeNuts ShoulderBolts			HeadBolts
	%		(yellow)
			@	@
@	@
Coupler	Bumper	Collars + spare Retaining Clips + spare

Hardware (blue bag)

Bumper

(remove backing)

@ Jfi

First Rail

Section

Coupler Power Head

Assembly

Figure 9 Install Bumper, Coupler and 1st Rail Section

Figure 10 Bolt 1st Rail Section to Power Head

11A. Slipon collar

1B. EngageHooks

11 C._Slide Collar over Hooks

11D._Snap on Retaining Clip

9