Genie 3531835447 installation instructions Monthly, Closedoor

Snap Lens Hinges into slots on back of Motor Cover

	60 Watts
Lens	maximum	Push in
@		Latches
		to
		close Lens

Figure 41 Install Lens Cover and Light Bulbs

AInstall two 60 Watt light bulbs (not included) into Light Sockets (Figure 41):

•Rough service, 130 Volt bulbs are recommended. IB Install Lens into slots in Motor Cover.

£Install Genie Emergency Release Kit (GER-2) accessory, if purchased.

DInstallation is now complete.

f

Transmitters comply with all United States and Canadian legal requirements asof the date of manufacture. No warranty is made that they comply with all legal requirements of any other jurisdiction. Iftransmitters are to be used in another country, the importer must determine compliance with any local laws and regulations which may differ from United States and Canadian requirements prior to use.

Los transmisores cumplen con todas las reglamentaciones legales de los Estados Unidos y del Canad& en la fecha de fabricaci6n. Ninguna garantia se da que cumpJan con todas as reglamentaciones legaJesde ninguna otra jurisdicci6n. Si los transmisores se van a utilizar en otro pais, el importador debe determinar sicumplen con las reglamentaciones y byes locales que puedan ser diferentes alas reglamentaciones de los Estados Unidos y del Canad4, antes de usar los mismos.

Les e_metteurssont conformes & la re_glementation am_ricaine et canadienne compter de leur date de fabrication. Aucune garantie n'eststipul@

indiquant qu'iJssont conformes _ toutes les prescriptions juridiques d'autres autorit_s. Si les _metteurs sont utilis@sdans d'autrespays, il incombe I'importateur d'end_terminer leur conformit_ aux lois et r@gleslocales pouvant diff@rerde celles des Etats-Unis et du Canada avant toute utiJisation desdits _metteurs.

Sendeger_ite entsprechen allen gesetzlichen Bestimmungen in den USA und Kanada zum Zeitpunkt der Herstellung.Wir ubemehmen keine Gew_ihrleistung for die Einhaltung alJergesetzlichen Bestimmungen in anderen L_ndern. SolJenSendeger_te in anderen L_inderneingesetzt werden, so muss der Importeur vor dem Gebrauch sicherstellen, dass die Sendeger_ite auch solchen Iokalen Bestimmungen entsprechen, welche von den Bestimmungen der USAund Kanadasabweichen.

AMonthly:

Door springs and door hardware:

-Oil door roller, bearings, and hinges using silicone lubricant or light oil.

WARNING

Do not operate door automatically or manually if springs

are broken. Contact a Genie Factory Authorized Dealer for service or call Customer Service at 1-800-35-GENIE.

•Balance Door.

-Closedoor.

-ReleaseMagnetic Carriage Assembly from Rail Assembly by pulling down on EmergencyReleaseKnob.

-Raise door manually 3'-4'and verify that door stays at that position. See Check Step 2 on page 3.

NOTE

When the door is 3'-4'above the ground, the door should stay open. Slight movement is acceptable. If

the door moves too much, contact a Genie Factory Authorized Dealer for service or call Customer Service at

1-800-35-GENIE.

-Reattach Magnetic Carriage Assembly to Rail Assembly:

a.Pull the Emergency Release Knob toward Power Head.

b.Close door.

Contact Reverse Test.

-Perform Installation Step 10 on page 21.

WARNING

If the door fails to reverse on contact with the board, adjust the Close Force Control as specified in Set Limit Switches and Force Controls on page 20. If the Opener

still fails, contact a Genie Factory Authorized Dealer for service or call Customer Service at 1-800-35-GENIE.

IB Yearly:

•Wipe off old excess lubricant from Drive Screw.

•Lubricate Drive Screw with Genie Lubricant (GLU-3)

NOTE

Use ONLY Genie Lubricant (GLU=3). Other lubricants may damage the Opener.

GLU-3

Lubricant

FCC AND IC CERTIFIED

_igb £_:d-,td,g:£_ b • 1-I_,o

J

All devices comply with Part lS of the FCCRules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includ- ing interference that may cause undesired operation.