Second Edition · Fifth Printing | Operator's Manual |
|
|
|
|
Collision Hazards
Be aware of limited sight distance and blind spots when driving or operating.
Be aware of boom position and tailswing when rotating turntable.
Check work area for overhead obstructions or other possible hazards.
Be aware of crushing hazard when grasping the platform guard rail.
It is recommended that operators wear an approved hard hat when operating the machine.
Observe and use
SAFETY RULES
Do not lower the boom unless the area below is clear of personnel and obstructions.
Limit travel speed according to condition of ground surface, congestion, slope, location of personnel and any other factors which may cause collision.
Do not operate a boom in the path of any crane unless the controls of the crane have been locked out and/or precautions have been taken to prevent any potential collision.
No stunt driving or horseplay while operating a machine.
Component Damage Hazards
Do not use any battery or charger greater than 12V to
Do not use machine as a ground for welding.
Be sure hydraulic shutoff valves (located by hydraulic tank) are open before starting engine.
Part No.43650 | Genie | 5 |
