Genie 43650 Transport Instructions, Securing to Truck or Trailer for Transit, Observe and Obey

Second Edition · Fifth Printing Operator's Manual

Transport Instructions

Observe and Obey:

Transport vehicle must be parked on a level surface.

Transport vehicle must be secured to prevent rolling while machine is being loaded.

Be sure vehicle capacity, loading surfaces and straps or lines are sufficient to withstand machine weight. See Specifications section.

Securing to Truck or Trailer for Transit

Always use the turntable rotation lock pin each time the machine is transported.

Always chock machine wheels in preparation for transport.

Use tie points on drive chassis for anchoring down to transport surface.

Disengage

Position

Engage

Position

Use lower platform mount between boom end and platform to secure boom from side-to-side movement. Do not use excessive downward force when securing boom section.

Use chains or straps of ample load capacity. Turn key switch to the OFF position and remove key before transporting.

Inspect entire machine for loose or unsecured items.

Free-wheel Configuration for Winching

Chock wheels to prevent machine from rolling. 2WD models: Release non-steer wheel brakes by turning over torque hub disconnect caps (see below).

4WD models: Release wheel brakes by turning over all four torque hub disconnect caps (see below).

Be sure winch line is properly secured to drive chassis tie points and path is clear of all obstructions.

Reverse procedures described to re-engage brakes.

Note: The pump free-wheel valve should always remain closed.

Part No. 43650 Genie S-80 & Genie S-85 27