3 BASIC OPERATION
■Call channel programming
The call channel switch is used to select Channel 9 by de- fault, however, you can program your most
q Push [DIAL] for 1 sec. to select the desired channel group (INT, USA) to be programmed.
w Push [16•C] for 1 sec. to select the call channel of the selected channel group.
- “CALL” and call channel number appear.
e Push [16•C] again for 3 sec. (until long beep changes to 2 short beeps) to enter call chan- nel programming condition.
-Call channel number and channel group to be programmed flash.
r Push [Y]/[Z] to select the de- sired channel.
t Push [16•C] to program the dis- played channel as the call chan- nel.
- The call channel number and chan- nel group stop flashing.
■Automatic backlighting
This function is convenient for nighttime operation. The auto- matic backlighting can be deactivated in SET mode. (p. 14)
•Push any key except for [PTT] to turn the backlighting ON.
-The backlighting is automatically turned OFF after 5 sec. of in- activity.
9
