Optional battery chargers | Genius IC-M21 guide

7 BATTERY CHARGING

■Optional battery chargers

DRapid charging with the BC-119N+AD-103

The optional BC-119N provides rapid charging of battery packs. The following are additionally required.

•AD-103

•An AC adapter (may be supplied with BC-119N depending on version).

IC-M21

BP-224

OPC-515L or

CP-17L

AD-103 charger adapter is installed in BC-119N.

AC adapter (BC-145E)

DRapid charging with the BC-121N+AD-103

The optional BC-121N allows up to 6 battery packs to be charged simultaneously. The following are additionally re- quired.

•Six AD-103.

•An AC adapter (BC-124) or the DC power cable (OPC-656).

IC-M21

BP-224

		AD-103 charger
	AC adapter	adapters are installed
	AC adapter	in each slot.
	(purchased	in each slot.
	(purchased
	separately)

DC power cable

(Connect with the DC power supply; 13.8 V/at least 7 A)

Page 24

Image 24

Genius IC-M21 Optional battery chargers, Rapid charging with the BC-119N+AD-103, Rapid charging with the BC-121N+AD-103

Contents

IM21 Clean the Transceiver Thoroughly with Fresh Case of Emergency Word Definition Rwarning May occurEquipment damage may occur If disregarded, inconvenience only. No riskPage Table of Contents Operating Rules PrioritiesPrivacy Radio licenses 0PTT Switch PTT Panel DescriptionFront, top and side panels Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteed Transmit Indicator p Busy Indicator pScan Indicator p Duplex Indicator 0BATTERY Indicator 5TRANSMIT Power Indicator3CHANNEL Number Readout Basic Operation Channel selectionChannel Call channel Adjusting the squelch level Push SQLMONI, then adjust the squelch level with Y/ZLock function Appears while the lock function is used Rotate OFF/VOL clockwise to turn power on Power on Set volume Push to Transmit Release to receiveSet squelch level Set output power Receiving and transmitting Call channel programming Automatic backlightingPush any key except for PTT to turn the backlighting on DUALWATCH/TRI-WATCH DescriptionOperation DUALWATCH/TRI-WATCH Simulation Scan Operation Scan typesPriority Scan Normal Scan Setting tag channels To cancel the tag channel setting, push Scntag for 1 secStarting a scan To stop the scan, push Scntag SET Mode SET mode programmingSET mode items Beep tone bP Scan resume timer St Scan indicator blinks while scanningAuto scan function AS Monitor action selection Sq Auto power save function PS Contrast of the LCD can be adjusted from 4 levelsLCD contrast selection LC Self check function SC Battery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery Charging Battery chargingBattery cautions Installing batteries Battery case Charging connections Optional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Supplied Accessories and Attachments Supplied accessoriesFlexible antenna Handstrap Swivel belt clip To attach To remove Troubleshooting Problem Possible Cause SolutionCeiver works properly or not Low power only Channel ListInternational channels Specifications and Options SpeciﬁcationsOptions 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan

Genius IC-M21 instruction manual Optional battery chargers, Rapid charging with the BC-119N+AD-103

Models: IC-M21

■Optional battery chargers

DRapid charging with the BC-119N+AD-103

DRapid charging with the BC-121N+AD-103