2 PANEL DESCRIPTION

ïBATTERY CASE RELEASE SCREW To remove the battery case:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery case:

Insert the battery case in the IC-M21 completely, then turn the screw clockwise.

NOTE: When removing or attaching the battery case, use a coin or flat-head screwdriver to loosen or tighten the bottom screw.

Screw position

when removing battery

LO

CK

 

OPEN

 

Screw position

when attaching battery

LO

CK

 

OPEN

 

CAUTION!:

When attaching or releasing a battery pack, make sure the rubber seal is set in the groove of the battery pack/case correctly. If the seal is not neatly in the groove it may be damaged when attaching the battery pack/case.

If the seal is damaged, water resistant is not guaranteed.

NOTE:

When attaching a battery pack/case, make sure dust etc. does not adhere to the rubber seal. If dust etc. is on the seal when attaching a battery pack/case, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust etc. does not adhere to it.

Correct position

Incorrect position

 

Rubber seal

 

Groove

Battery pack/case

Battery pack/case

3

Page 8
Image 8
Genius IC-M21 instruction manual Battery Case Release Screw To remove the battery case