Battery Charging, Battery charging | Genius IC-M21 specification

7 BATTERY CHARGING

■Battery charging

Prior to using the transceiver for the ﬁrst time, the Ni-Cd bat- teries must be fully charged for optimum life and operation.

CAUTION: To avoid damage to the transceiver, turn it OFF while charging.

•Recommended temperature range for charging:

+10°C to +40°C (+50°F to +104°F)

•Use the supplied charger (BC-150) only. NEVER use an other manufactures charger.

NEVER connect DC power to the battery case when in- stalling alkaline batteries. Such a connection will damage the transceiver.

■Battery cautions

NEVER incinerate used Ni-Cd batteries. Internal battery gas may cause an explosion.

NEVER immerse batteries in water. If the battery case be- comes wet, be sure to wipe it dry BEFORE attaching it to the transceiver.

NEVER short terminals of the battery case. Also, current may ﬂow into nearby metal objects so be careful when placing bat- tery cases in handbags, etc.

If your Ni-Cd batteries seem to have no capacity even after being charged, completely discharge them by leaving the power ON overnight. Then, fully charge the Ni-Cd batteries again. If the batteries still do not retain a charge (or very little), new batteries must be purchased.

17

Image 22

Genius IC-M21 instruction manual Battery Charging, Battery charging, Battery cautions

Contents

IM21 Clean the Transceiver Thoroughly with Fresh Case of Emergency Equipment damage may occur Word Definition RwarningMay occur If disregarded, inconvenience only. No riskPage Table of Contents Privacy Operating RulesPriorities Radio licenses Panel Description 0PTT Switch PTTFront, top and side panels Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteed Scan Indicator p Transmit Indicator pBusy Indicator p Duplex Indicator 5TRANSMIT Power Indicator 0BATTERY Indicator3CHANNEL Number Readout Channel Basic OperationChannel selection Call channel Lock function Adjusting the squelch levelPush SQLMONI, then adjust the squelch level with Y/Z Appears while the lock function is used Set squelch level Set output power Rotate OFF/VOL clockwise to turn power onPower on Set volume Push to Transmit Release to receive Receiving and transmitting Automatic backlighting Call channel programmingPush any key except for PTT to turn the backlighting on Operation DUALWATCH/TRI-WATCHDescription DUALWATCH/TRI-WATCH Simulation Priority Scan Scan OperationScan types Normal Scan Starting a scan Setting tag channelsTo cancel the tag channel setting, push Scntag for 1 sec To stop the scan, push Scntag SET mode items SET ModeSET mode programming Beep tone bP Auto scan function AS Scan resume timer StScan indicator blinks while scanning Monitor action selection Sq LCD contrast selection LC Auto power save function PSContrast of the LCD can be adjusted from 4 levels Self check function SC Meter/RF meter indicator Sr Battery voltage indicator btFunction Indication Switch Battery charging Battery ChargingBattery cautions Installing batteries Battery case Charging connections Rapid charging with the BC-119N+AD-103 Optional battery chargersRapid charging with the BC-121N+AD-103 Flexible antenna Supplied Accessories and AttachmentsSupplied accessories Handstrap Swivel belt clip To attach To remove Problem Possible Cause Solution TroubleshootingCeiver works properly or not Channel List Low power onlyInternational channels Speciﬁcations Specifications and OptionsOptions 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan