Take off the upper cover and remove the screws | Giantec tracer2000

tracer2000 Network DVR Hardware User’s Manual

2.Take off the upper cover and remove the screws.

Remove the screw.

Version 3.1

Page 29 of 31

Image 37

Giantec tracer2000 manual Take off the upper cover and remove the screws

Contents

Tracer2000 Page Warranties Copyright NoticeTrademarks Page Email for technical support Giantec Internet ServicesWorld Wide Web WWW site for product information Page Table of Contents Chapter System HDD Installation Guide Chapter Introduction Limited WarrantyFunction Introduction Before proceeding, please read this manual thoroughly Features Chapter Package Chapter Installation Cable Connection IndicatorConnect VGA Monitor Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Chapter Pin Assignment Internal Jumpers and Connectors Reset / LED / Speaker JP1 Power Switch for ATX Power Supply JP1 SignalsPower Connector P1 Signals Cmos Clear J1 HDD Connector IDE1 Pin No COM2 Mode Select JP3CPU FSB Select JP4 Function FAN Control FAN1 Function Video Input J2 Pin No Parallel / Printer Connector PRN Pin No Infra-Red IR Pin No Signal General Purpose Input / Output J3 Pin No Signal PCI Bus Pin Assignment CRT Display Connector VGA Pin No Signal External ConnectorAudio Input Connector Gpio Connector USB Connector USB Ports COM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin No COM1 Connector RS232 Connector COM1 Pin No Signal Drawing of Ethernet Connector RJ-45 Pin No Signal Ethernet Connector RJ-45Connectors Component Label RS232 / RS422 / RS485 Connector COM2 Pin No P/T/Z SettingJumper 3 Setting of COM2 Pin Assignment of COM2 Setup Pages Chapter Cmos SettingIntroduction EGA/VGA Standard Cmos Features CD-ROM Advanced Bios Features Advanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual SPP Integrated Peripherals Dpms Power Management Setup PC Health Status PnP / PCI Configuration Supervisor / User Password Load Optimized DefaultsSave & Exit Setup Frequency / Voltage Control Remove the screws on the case. Marked in while circles Chapter System HDD Installation Guide Take off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual