Remove HDD tray, and install HDD properly | Giantec tracer2000

tracer2000 Network DVR Hardware User’s Manual

3.Remove HDD tray, and install HDD properly.

Version 3.1

Page 30 of 31

Image 38

Giantec tracer2000 manual Remove HDD tray, and install HDD properly

Contents

Tracer2000 Page Trademarks Copyright NoticeWarranties Page World Wide Web WWW site for product information Giantec Internet ServicesEmail for technical support Page Table of Contents Chapter System HDD Installation Guide Function Introduction Limited WarrantyChapter Introduction Before proceeding, please read this manual thoroughly Features Chapter Package Chapter Installation Connect VGA Monitor IndicatorCable Connection Connect Camera Cable to BNC Connector Connect to Printer Port Option Power Connector Internal Jumpers and Connectors Chapter Pin Assignment Power Connector P1 Signals Power Switch for ATX Power Supply JP1 SignalsReset / LED / Speaker JP1 Cmos Clear J1 CPU FSB Select JP4 Function COM2 Mode Select JP3HDD Connector IDE1 Pin No FAN Control FAN1 Function Parallel / Printer Connector PRN Pin No Video Input J2 Pin No General Purpose Input / Output J3 Pin No Signal Infra-Red IR Pin No Signal PCI Bus Pin Assignment Audio Input Connector Gpio Connector External ConnectorCRT Display Connector VGA Pin No Signal USB Connector USB Ports COM1 Connector RS232 Connector COM1 Pin No Signal COM2 Connector RS232 / RS422 / RS485 Connector COM2 Pin No Connectors Ethernet Connector RJ-45Drawing of Ethernet Connector RJ-45 Pin No Signal Component Label Jumper 3 Setting of COM2 P/T/Z SettingRS232 / RS422 / RS485 Connector COM2 Pin No Pin Assignment of COM2 Introduction Chapter Cmos SettingSetup Pages Standard Cmos Features EGA/VGA Advanced Bios Features CD-ROM Advanced Chipset Features Tracer2000 Network DVR Hardware User’s Manual Integrated Peripherals SPP Power Management Setup Dpms PnP / PCI Configuration PC Health Status Save & Exit Setup Load Optimized DefaultsSupervisor / User Password Frequency / Voltage Control Chapter System HDD Installation Guide Remove the screws on the case. Marked in while circles Take off the upper cover and remove the screws Remove HDD tray, and install HDD properly Tracer2000 Network DVR Hardware User’s Manual