Glen Dimplex Home Appliances Ltd GT 755, GT 756 manual Gas Supply

Gas Supply

Stability Chain

Flame Failure Device

Flame failure device

worktops (excluding handles). To achieve the best fit the cooker must be pushed against the wall. If the wall mounted adapter backplate (Fig.1) is to be fitted behind the appliance then the suitable area for this fitting is shown as the area in (Fig.2).

The temperature rise of areas at the reara of the cooker that are likely to come into contact with the flexible hose do not exceed 70°C. However, do not allow contact of the hose in the top 150mm/6 inches (the shaded area shown in Fig.3).

A Rp 1/2 union is fitted to the cooker. Connection to the appliance should be made with an approved appliance flexible connection to BS669. The length of the hose should be such that when the cooker is in situ, it does not touch the floor.

The cooker must be secured by a security chain to the wall or partition behind the cooker. (Fig.4)

All burners are protected by flame failure devices, if the flames are extinguished for any reason the gas will automatically be cut off.

The burner control knobs have a safety feature.

1Push the appropriate knob in slightly and turn anti-clockwise to the required setting.

2While keeping the knob depressed press the ignition button. /4;

3Keep the knob depressed for 15 seconds after the burner has lit to override the safety device.

If still no ignition occurs, wait for 1 minute and repeat again.

Warning: Do not keep the knob in pressed position more than 15 seconds.

4To switch a burner off turn the corresponding knob to I.

•Turning the control knob fully anti-clockwise to the small flame symbol enables you to simmer without accidently switching off.

Fig.1 Fig.2

A=150

B=175

C=700

D=500

E=150

Fig.3	Fig.4
		%NMI hook
		;rot '4'ppl:c:d.)
The hose must
not come into
contact with
the shaded			coc.kef rear
area

6