LOG SET INSTALLATION INSTRUCTIONS
Log Installation
The gas log set (front left log, front right log, center log and rear log) is
1.To access the log set parcel, lift off top panel.
2.Pivot left and right panels open.
3.Unlatch main door latches located on right and left hand side of the heater, remove door.
4.Carefully remove top left log and top right log from firebox and remove cardboard protection from center log and middle log and all packaging materials.
Note: Positions of front left log, front right log, center log, and rear log have been preset at the factory and their loca- tions should not be changed. Check that logs have not been damaged in transit.
5.Carefully remove wrapping from top left log and top right log.
Note: Before you begin: Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash your hands gently with soap and wa- ter.
All Logs
The positioning of the logs is critical to the safe and clean opera- tion of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance.
6.Prior to positioning of top left log and top right log, inspect front burner and rear burner for particles or dust accumula- tion on top of burners. If any particles or dust is visible on top of front or rear burners, remove particles before placing top left log and top right log into position.
7.Position top left log into locating pin on rear log and rest on center log. See Figure 12.
8.Position top right log into locating slot on rear log. See Fig- ure 12.
9.After top left log and top right log have been placed in posi- tion and safety check has been carried out, install door and latch securely with latches located on right and left side of heater.
TOP LEFT LOG
REAR LOG
TOP RIGHT LOG
CENTER LOG
FRONT RIGHT LOG
FRONT LEFT LOG
Figure 12
Page 16 |
