GN National Electric BP)-1, PV-28SV50, GN, GP)-1 Log Placement, Main Convection Fan, Heat Exchanger

LOG PLACEMENT

If for any reason a log should need replacement, you must use the	Note: Improper positioning of logs can create carbon build up
proper replacement log. Consult your Mantis dealer for correct	and will alter the unit’s performance and operation.
replacement logs.
Replacement logs must be installed and positioned as outlined on
pages 16 through 17 under Log Installation.

MAIN CONVECTION FAN

The main convection fan in the heater should be checked, ser-	Note: If the main convection fan becomes clogged with lint and
viced and cleaned annually by a qualified service person to ensure	dust an over-temperature situation will occur through the
that your appliance is operating efficiently.	heater exchange system and the over-temperature safety
	switch will stop the heater from operating.

HEAT EXCHANGER

The heat exchanger of the unit is located at the rear of the heater. The heat exchanger should be inspected annually by a qualified service person for lint and dust build up. Excessive dust and lint build-up in the heat exchanger can alter the unit’s performance and operation.

Note: This appliance (Insert and Freestanding Models) needs to be installed in such a way that the heater (especially with models built into a fireplace) can be removed at all times to service the heat exchanger and flue fan, which

are located at the rear section of the heater.

Under no circumstances should the appliance be installed under conditions that would not allow for easy removal of the appliance to carry out routine inspection and ser- vice work on the appliance.

DISCONNECT MAIN POWER PRIOR TO STARTING ANY WORK ON THE APPLIANCE.

22618-4-1106 Page 39