Graco 244561 Remote Operator Stations, Power Switch a, Operation Mode Switch B and Key C

Overview

Power Switch (A)

On = Off = .

(On side of controller)

Operation Mode Switch (B) and Key (C)

		The position of the switch (B) determines which mode of operation you are in:
		Dispense Mode	or Setup Mode . A key (C) supplied with the ProDispense system is
A	B	inserted into the switch and turned to change operation modes. The key cannot be removed
		while the system is in Setup Mode.
		Dispense Mode	is used to dispense a recipe, fluid, check fluid totals, and to view the
C		alarms log.

Setup Mode is used to configure the system, fluid, and recipe parameters, and to cali- brate the meters.

STOP

DISPENSE

AUTO ON

DISPENSE

START

ti1359a

Stop button

Dispense switch

Start button

Remote Operator Stations

A cable connects the operator station to the fluid panel junction box. A separate operator sta- tion is needed for each fluid panel installed on the system. The dispense switch can be set to dispense automatically (AUTO) or manually (ON).

If set to AUTO, the fluid panel will dispense when a recipe or fluid dispense is selected with the controller and the start button is pressed either on the controller or the operator station. The dispense will stop when the preset amount is reached or when the stop button is pressed on either the controller or the operator station.

If set to ON, the fluid panel will begin dispensing immediately or when the dispense valve is triggered. The dispense is stopped by releasing the trigger or turning the dispense switch to AUTO or pressing the STOP button on the operator station.

309301G 11