![](/images/new-backgrounds/1209539/20953919x1.webp)
Sprayer Setup
Use only
Spraying certain materials may cause static
Use
Keep spray area
NOTICE
Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach. Using these cleaners will cause damage to the sprayer.
This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material from the sprayer before using it for the first time:
1.Fill material cup with water or compatible solvent, thread onto sprayer and hand tighten.
ti18871a
Sprayer Setup
2.Put prime/spray valve to UP position, then hold trig- ger in for 10 seconds.
ti16700ati14999a
3. Put prime/spray valve DOWN to spray position.
ti16701a
ti15425a
4.Reverse Spray Tip to UNCLOG position and trigger sprayer into a waste area for 10 seconds.
ti14991a | ti16713a |
| |
| ti15491 |
5.Engage trigger lock and put prime/spray valve UP to release pressure.
ti18866a | ti14999a |
|
ti14994a | ti16700a |
6.Unscrew and remove material cup.
7.Disengage trigger lock, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.
ti18861a
8. Discard material in cup.
10 | 3A2589D |