Charging the Battery
Charging the Battery
Replace and charge battery only in a
Batteries are initially 50% charged to provide optimum battery life and require charging before first use. It takes approxi- mately 45 minutes to charge a dead battery to 80%, at which point it can be used. It will take approximately 75 minutes to fully charge a dead battery.
1.Place charger in a dry,
2.Plug charger into an electrical outlet and slide battery into charger as shown (light will turn on in 5 seconds).
ti14990a
ti14990a
3.When battery becomes fully charged, immediately unplug the charger from the power supply and remove the battery from the charger.
NOTE: The amount sprayed with each battery varies depend- ing on material, spray tip size, battery charge, and battery tem- perature. One battery fully charged will spray up to one gallon. Amount sprayed will be less depending on spray tip size, material sprayed, life of battery, temperature, and other envi- ronmental factors.
Charger Status Indicator Lights
NOTE: When the charger is plugged in, the charger status indicator lights will alternate between green and red several times before they turn off, indicating that the charger is ready to charge a battery.
|
|
| Label | Appearance | Description | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Solid green light | Indicates a full charge. Battery can be used. |
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Flashing green light | Battery is charging, indicates 80% charge. |
|
|
|
|
|
|
|
|
|
|
| Battery can be used. | |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Flashing red light | Battery is charging, indicates less than 80% charge. |
|
|
|
|
|
|
|
|
|
|
| Do NOT use battery. | |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Solid red light | Battery is too hot or too cold to charge. Remove battery and allow to cool or |
|
|
|
|
|
|
|
|
|
|
|
| warm up before charging. |
|
|
|
|
|
|
|
|
|
|
|
|
|
Sprayer Status Indicator Light
Light* | Appearance | Description |
ti18884a | No light | Normal operation. |
| Solid red | Battery is low on power and needs to be charged, or battery is too cold and |
|
| must warm up before spraying. |
| Flashing red | Battery temperature is too high, or spray tip is clogged. |
|
| See Troubleshooting, page 27. |
*NOTE: The sprayer status indicator light is only visible when sprayer trigger is engaged. You must squeeze and hold the trigger to see the sprayer status indicator.
6 | 3A2589D |
