Graco 3A2589D important safety instructions Storage, Cleaning Sprayer Exterior

Storage

Cleaning Sprayer Exterior

Wipe paint off outside of sprayer using a soft cloth moist- ened with water or flushing fluid. Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F (38° C). Do NOT submerge the

sprayer.

ti18879a

Storage

NOTICE

Failure to store sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after cleaning.

Water or solvents other than mineral spirits left in the sprayer will corrode and damage the pump.

1.Lift prime/spray valve UP to the prime position. Remove material cup and flexible suction tube.

ti16700a

ti18869a ti18870a

2.Remove child-resistent cap. Thread nozzle onto Pump Armor bottle. NOTE: For best results, make sure bottle is full.

ti18067a

3.Hold sprayer upside-down over a waste container.

ti18862a

4.Insert Pump Armor nozzle over material inlet and push firmly until it stops. Squeeze cleaning bottle until Pump Armor flows out drain tube.

ti18066a ti18177a

5.Remove Pump Armor nozzle and replace child-resistent cap and tighten securely for storage.

ti18069a

6.Attach flexible suction tube and material cup. Push valve DOWN to spray position.

ti16701a

ti18872a

ti18871a

7.Recharge battery to full charge before storage. See Charging the Battery, page 6.

8.Store sprayer indoors in a cool, dry place. Store in an upright position only. Never store sprayer with material in the cup.

ti18885a

3A2589D 17