7.Reconnect material cup and shake sprayer to move clean water around and clean all areas inside of mate- rial cup.
Shutdown and Cleaning
12.Engage trigger lock and put prime/spray valve UP to release pressure.
ti15441a
8.Disengage trigger lock and trigger sprayer for approxi- mately 15 seconds. Engage trigger lock.
ti18874a | ti16716a | ti18866a |
|
|
9.Discard contaminated fluid and refill with appropriate flushing fluid.
10.Disengage trigger lock, reverse Spray Tip to UNCLOG position, and pull trigger for 5 seconds to prime sprayer.
ti16700a ti18866a 
ti14994a
NOTE: Air vent holes or the air vent valve (as your model is equipped) allow air to flow into the material cup while spraying to prevent loss of fluid flow.
13.Remove material cup and discard used fluid.
For model 16N660: Use a soft brush to clean the black rubber inlet seal. If vent holes become clogged, use a paper clip to clear the holes.
ti17326a ti17323a
For all other units: Remove air vent valve, clean, and reinstall.
ti18874a | ti14991a |
11.Put prime/spray valve DOWN to spray position. Trigger sprayer into waste area until no paint appears in water or flushing fluid.
ti16701a | ti16713a |
ti15425a |
ti18876a
14.Remove spray/tip guard assembly and clean with water or flushing fluid. A soft brush can be used to loosen and remove dried material if needed.
To avoid serious injury or damage to equipment, do not expose the sprayer electronics to flushing solvents. Keep sprayer at least 10 in. (25 cm) above the rim of the con- tainer when flushing.
ti15529ati19009a
Keep spray area
ti15703a 
ti15705a | ti15547a |
|
NOTICE
The spray tip is permanently attached to the guard. Removing the spray tip from the guard will result in dam- age to the spray tip assembly. Do not store spray/tip guard assembly or flexible suction tube in solvent other than mineral spirits. Damage to parts may occur.
16 | 3A2589D |
