LF1041 only: attaching | boom | |
actuator / motor, | ||
| ||
power bracket, |
| |
components |
| |
Tools needed: Phillips screwdriver, | mounting | |
M3 hex key | points |
mast | power bracket |
| Phillips head screw |
1. Attach actuator / motor to |
boom and mast using the |
at near right; note that |
mast
mount |
|
| secure |
|
power bracket |
|
| power bracket |
|
|
|
|
|
|
illustration shows mounting |
points after assembly; shown |
components will not yet be present. |
attach actuator / motor to boom and mast
control box
socket head cap screw
2. | Use Phillips screwdriver to remove the three Phillips |
| heads screws on the back of the mast. Position power |
| bracket on mast as shown at upper far right. Secure |
| power bracket to mast by installing the Phillips head |
| mast screws as shown at upper far right (top screw is |
| shown). Use Phillips screwdriver to tighten. |
3. | Mount control box on mast by sliding its lower end onto |
| power bracket lip, as shown at near right. Secure control |
mount |
control box |
secure |
control box |
box by installing socket head cap screw at top of control |
box, as shown at far right. Use M3 hex key to tighten. |
4. Mount battery charger on mast by sliding it onto power |
bracket lip so it rests on top of control box. Secure |
battery charger by installing socket head cap screw at |
top of battery charger, as shown at right. Use M3 hex key |
to tighten. |
socket head cap screw
secure
battery charger
5.Mount battery to mast by sliding it onto top power bracket lip so it rests on top of battery charger, and boss on battery back fits into power bracket hole.
battery |
battery boss |
power bracket hole |
mount battery
6.The control box, battery charger, and battery are shown correctly mounted on the mast at right.
7. Continue to next page for electrical power connections. | battery |
|
battery 
charger
control box 
power components mounted
| 11 |
