Grandstream Networks GXP11O5 Dtmf, Enable Flash key as, Conf, Disable Transfer Auto-Attended

Call Progress Tones

Disable Call Waiting

Disable Call

Waiting Tone

Disable Direct IP Calls

Use Quick IP Call Mode

Disable Conference

Enable MPK sending

DTMF

Enable FLASH key as

CONF

Disable Transfer

Auto-Attended

Transfer

Using these settings, users can configure ring or tone frequencies based on parameters from local telecom. By default, they are set to North American standard. Frequencies should be configured with known values to avoid uncomfortable high pitch sounds.

Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]]; (Frequencies are in Hz and cadence on and off are in 10ms)

ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up to three cadences are supported.

Default is “No”. If set to “Yes”, the call waiting feature will be disabled.

Default is “No”. If set to “Yes”, the call waiting tone will be disabled.

Default is “No”. If set to “Yes”, direct IP calls will be disabled.

Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP address.

In the Advanced Settings page there is an option “Use Quick IP-call mode”. Default setting is “No”. When set to “Yes”, and #XXX is dialed, where X is 0-9 and XXX <=255, phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet mask.

#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode for details.

Default is “No”. If set to “Yes”, 3-way conference will be disabled

Default is No. If set to “Yes”, Multi Purpose keys can be sent as DTMF during the call.

Default is No. If set to “Yes”, FLASH key can be used to establish 3-way conference.

Default is “No”. If set to “Yes”, transfer will be disabled.

Default is “No”. If set to “Yes”, the phone will use attended transfer by default.

Grandstream Networks, Inc.	GXP1100/1105 User Manual	Page 23 of 34
	Firmware version: 1.0.1.110	Last Updated: 01/2012