OPERATING
A
MX9269
3.With a second person holding the handlebar grips firmly, loosen and remove bolts (A) from both sides of machine.
4.With bolts removed from machine, tilt rear of machine up or down by handlebar grips to accommodate height desired.
NOTE: The cut height range is set by the way the upper traction deck is bolted to the mower deck.
•Bolting the upper traction deck holes to the lower mower deck holes sets the cut height range at 89- 108mm
•Bolting the upper traction deck holes to the upper mower deck holes sets the cut height range at 64- 83mm
•Bolting the lower traction deck holes to the upper mower deck holes sets the cut height range at 38- 57mm
5.Insert bolts into desired holes and tighten to
B
MX9257
6.Front mower deck height can be adjusted by moving shims (B). Each shim is equal to 13mm (0.5 in.) of adjustment.
Using the Fuel Shutoff Valve
Move the fuel shutoff valve to the on position for normal operation. Move the fuel shutoff valve to the off position when the machine is not in use, transported or trailered.
Moving the Machine Manually
cCAUTION: Avoid injury! With the machine in neutral, the machine will have unrestricted motion.
•The machine may
•Park the machine on a level surface before moving machine into neutral position.
IMPORTANT: Avoid damage! Transmission damage may occur if the machine is moved or towed incorrectly:
•Move unit by hand only.
•Do not use another vehicle to move unit.
•Do not tow unit.
1.Park machine safely. (See Parking Safely in the Safety section.)
2.Move transmission drive/bypass/park brake selector into neutral position.
3.Push machine to desired location. Due to internal hydraulic system resistance, the machine will move slowly.
4.Move transmission drive/bypass/park brake selector into park brake position.
Operating - 10
