Great Dane GDRZ52-23KAE Adjusting Mower Deck Anti-Scalp Wheels, Using the Park Brake, Operating

OPERATING

A

B

D

C

2. Adjust mower deck to desired cutting height.

NOTE: The rear anti-scalp wheels are located under the rear of the mower deck.

MX13149

2.	Move the mower deck lift lever (A) to the transport
position (D).
3.	Position the HOC adjustment pin (C) in the proper hole

A

B

C

MX15281

for the desired height-of-cut.

4. Pull back and hold the mower deck lift lever (A) and

release the transport position lock lever (B).

A

C

MX13155

5.Allow the mower deck lift lever (A) to rest against the HOC adjustment pin (C).

Adjusting Mower Deck Anti-Scalp Wheels

c CAUTION: Avoid injury! Fingers or loose clothing can get caught in rotating parts. Stop engine and wait for all moving parts to stop before servicing.

NOTE: The flattest cut can be achieved by having all anti-scalp wheels adjusted off the ground. Check anti- scalp wheel adjustments each time the mower deck cutting height is changed.

It is recommended that all anti-scalp wheels be kept off the ground to minimize scuffing.

1. Inflate tires to correct pressure.

3.Adjust anti-scalp wheel (A) to one of two positions (B).

•Remove screw (C), nut and washer.

•Adjust wheel up or down so it is approximately 6-13 mm (1/4-1/2 in.) above mowing surface.

4.Install wheel with attaching hardware.

5.Adjust all wheels to same height.

Using the Park Brake

c CAUTION: Avoid injury! Children or bystanders may attempt to move or operate an unattended machine.

Always lock the park brake and remove the key before leaving the machine unattended.

Locking Park Brake:

c CAUTION: Avoid injury! If the engine should stop while operating on an incline, the mower will free-wheel. If this should occur, lock the park brake, start the engine, unlock the park brake and resume operation.

Operating - 13