Great Dane GDRZ52-25KHE manual Mounting and Dismounting Machine Safely, Adjusting Seat, Operating

OPERATING

Mounting and Dismounting Machine Safely

A

MX15340

Do not step on the mower deck when mounting and dismounting the machine. Mount the machine from the front using the foot plate (A). Park machine safely (see Parking Safely in the Safety section) before dismounting.

Keep the foot plate clean.

Raising and Lowering Operator Seat

c CAUTION: Avoid injury! The seat is heavy and can cause injury if it falls. When performing any service function under the operator seat, make sure the seat is tilted forward and rests against the hinge stops.

Raising the Seat:

1.Park machine safely. (See Parking Safely in the Safety section.)

2.Slide seat to full rear position.

A

MX15282

3.Lift seat frame (A) and tilt forward until it rests against the hinge stops.

Lowering the Seat:

1.Stand on the side of the machine.

2.Push operator seat back and slowly lower seat frame.

Adjusting Seat

Front-to-Back Adjustment

1. Sit on the operator seat.

BA

MX15280

Picture Note: Chariot LX suspension seat shown.

2.To adjust the seat front to back, push and hold the seat adjustment lever (A) away from the seat.

3.Slide forward or backward to desired position.

4.Release lever.

Seat Height Adjustment (Chariot LX only)

1.Sit on the operator seat.

2.To lower the seat, turn knob (B) counterclockwise.

3.To raise the seat, turn knob (B) clockwise.

Adjusting Mower Deck Cutting Height

c CAUTION: Avoid injury! Before adjusting cutting height, stop engine and lock the park brake.

Cutting height can be adjusted from approximately 25-125

mm(1-5 in.). Each hole adjusts the height-of-cut (HOC) in approximately 12 mm (1/2 in.) increments.

The deck can also be raised and locked in a transport position, to provide maximum ground clearance when moving the machine from one area to another.

1.Park machine safely. (See Parking Safely in the Safety section.)

Operating - 12