Great Dane GDRZ61-25KHE Install Motion Control Levers, Install Seat, Lubricate Machine, Assembly

ASSEMBLY

Install Motion Control Levers

A

MX15343

1. Remove hardware from control arms.

NOTE: The control lever mounting brackets have six holes. The levers can be installed in the top four holes, or for a lower lever position, install the levers in the lower four holes.

2.Align motion control levers (A) with control arms. Install hardware and tighten.

3.Check motion control lever alignment.

• Move both motion control levers forward.

Install Seat

1. Remove protective covers from seat screws.

B

D

A

CC

MX15344

2.Pivot seat frame (A) forward until it rests on the hinge stops.

NOTE: The seat mounting hardware is attached to the seat plate with tie straps.

3.Install seat (B) to the seat frame, using four 5/16-18 locknuts and heavy flat washers (C). Tighten locknuts to 27 N•m (20 lb-ft).

4.Connect wire harness to seat safety switch (D).

Lubricate Machine

Lubricate all moving parts before operating the machine. See Lubrication Points in the Service Lubrication section.

Check Mower Deck Level

The mower deck is assembled and adjusted at the factory. After machine is completely assembled, check the mower front-to-rear and side-to-side deck level.

Check Safety System

For a complete checkout procedure of the safety interlock system, see Testing the Safety Interlock System in the Operating section.

Assembly - 66