Great Dane GDRZ52-25KAE, GDRZ72-27KHE, GDRZ61-25KAE, GDRZ61-28KHE, GDRZ61-26KHE manual Service Mower

SERVICE MOWER

5.Remove retaining ring (I), spindle shaft (J), lower bearing (K) and spacer (L) from spindle housing (M). Discard bearing.

6.Remove and discard upper bearing (N).

7.Clean entire assembly.

8.Install a new lower bearing (K) and spacer (L) on the spindle shaft (J).

IMPORTANT: Avoid damage! The clearance between the lower bearing and the housing is only 0.05 mm (0.002 in.). Do not force bearing into housing.

9.Install the spindle shaft (J), lower bearing (K) and spacer

(L) into the spindle housing (M).

10.Install the upper bearing (N) and retaining ring (I).

11.Install upper pulleys:

•Right and Left Spindles (A): Install pulley (D), spacer (C) and nut (B). Tighten nut to 81 N•m (60 lb-ft).

•Center Spindle (E): Install spindle pulley (H), drive pulley (G) and nut (F). Tighten nut to 81 N•m (60 lb-ft).

12.Install mower blade, blade washers and blade bolt assembly. Tighten nut to 81 N•m (60 lb-ft). (See Checking and Replacing Mower Blades.)

Service Mower - 50