Great Dane GDRZ61-27KHE manual Bag of Parts, Prepare for Assembly, Check Hydraulic Oil Level

ASSEMBLY

Bag of Parts

Qty.	Description
1	Key
1	Operator’s Manual
1	PDR Check List

Prepare for Assembly

•Remove machine from the shipping crate:

•Remove box containing operator seat.

•Cut plastic tie straps fastening the front wheels to the shipping crate.

•Cut plastic tie straps holding the discharge chute up.

•Cut plastic tie straps securing the motion control levers to the machine.

Check Hydraulic Oil Level

IMPORTANT: Avoid damage! Check all fluid levels before attempting to start the machine. Machine should be parked on a hard, level surface with the key switch in the STOP position.

1.Park machine safely. (See Parking Safely in the Safety section.)

A

MX15294

2.Unscrew and remove hydraulic reservoir cap/dipstick (A) from hydraulic oil reservoir.

3.Wipe dipstick with a clean cloth.

4.Install dipstick and allow the cap to rest on the end of the tube. Do not tighten the cap.

5.Remove dipstick and check oil level. Oil level should be at top mark on dipstick.

6.If necessary, add oil through oil reservoir filler neck.

7. Install cap on filler neck.

Check Engine Oil Level

Remove dipstick from tube by unscrewing it. Wipe it clean.

8.Install dipstick and allow the cap to rest on the end of the tube. Do not tighten the cap.

9.Remove dipstick. Check oil level on dipstick; oil level should be between the ADD and FULL marks.

•If oil is low, add oil to bring oil level no higher than the FULL mark on dipstick.

•If oil level is above the FULL mark, drain to proper level.

10.Install and tighten dipstick.

Check Tire Pressure

c CAUTION: Avoid injury! Explosive separation of a tire and rim parts can cause serious injury or death:

•DO NOT attempt to mount a tire without the proper equipment and experience to perform the job.

•Always maintain the correct tire pressure. DO NOT inflate the tires above the recommended pressure. Never weld or heat a wheel and tire assembly. The heat can cause an increase in air pressure resulting in a tire explosion. Welding can structurally weaken or deform the wheel.

•When inflating tires, use a clip-on chuck and extension hose long enough to allow you to stand to one side and NOT in front of or over the tire assembly.

•Check tires for low pressure, cuts, bubbles, damaged rims or missing lug bolts and nuts.

1.Check tires for damage.

2.Check tire pressure with an accurate gauge.

3.Check that tires have correct pressure. Add air, if necessary:

Tire Size	Pressure
Front: 13 x 5.0-6	110-138 kPa (16-20 psi)
Rear - Chariot: 23 x 9.5-12	69-97 kPa (10-14 psi)
Rear - Chariot LX: 24 x 12-	69-97 kPa (10-14 psi)
12

Assembly - 65