Great Dane GDRZ61-28KHE Remove and Install Rear Drive Wheels, Service Miscellaneous, MX15322

SERVICE MISCELLANEOUS

Remove and Install Rear Drive Wheels

Removing:

1.Park machine safely. (See Parking Safely in the Safety section.)

A

B

MX15322

2.Slightly loosen five wheel nuts (A).

3.Lift machine with a safe lifting device.

4.Remove wheel nuts.

5.Remove wheel and tire assembly (B).

Installing Rear Drive Wheels/Tightening Hardware:

1. Install new wheel and tire assembly.

M77000

2.Install and tighten wheel nuts in numbered sequence shown for safe wheel installation. Tighten alternately until recommended torque value is reached.

• Tighten nuts to 100 N•m (75 lb-ft).

3.Lower machine.

Cleaning and Repairing Metal Surfaces

Cleaning:

Follow automotive practices to care for your machine’s painted metal surfaces. Use a high-quality automotive wax regularly to maintain the factory look of your machine’s painted surfaces.

Repairing Minor Scratches (Surface Scratch):

1. Clean area to be repaired thoroughly.

IMPORTANT: Avoid damage! Do not use rubbing compound on painted surfaces.

2.Use automotive polishing compound to remove surface scratches.

3.Apply wax to entire surface.

Repairing Deep Scratches (Bare Metal or Primer Showing):

1.Clean area to be repaired with rubbing alcohol or mineral spirits.

2.Use factory-matched colors available from your Great Dane dealer to fill scratches. Follow directions included on container for use and for drying.

3.Smooth out surface using an automotive polishing compound. Do not use power buffer.

4.Apply wax to surface.

Service Miscellaneous - 58