Great Dane GDRZ48-17KAE, GDRZ72-27KHE manual Adjusting Park Brake, Service Steering & Brakes

SERVICE STEERING & BRAKES

NOTE: If the ends of the levers strike against each other while in the neutral position, move the levers to the neutral lock position and carefully bend them outward. Move them back to the neutral position and check for the recommended gap of 3-6 mm (1/8-1/4 in.).

•If positions of the control levers are unequal, an adjustment is necessary.

Alignment Procedure

1. Adjust position of motion control levers:

C

MX15353

•Loosen capscrews (C).

•Slide both levers forward or rearward to desired position on control arm until levers are aligned.

•Tighten capscrews.

Adjusting Park Brake

IMPORTANT: Avoid damage! Due to initial brake wear, the park brake should be checked and adjusted after the first 25 hours of use.

A park brake that is adjusted too tightly could damage the transmission or cause premature brake wear.

1.Park machine safely. (See Parking Safely in the Safety section.)

A

B

MX13130

2.Loosen set screw (A).

3.Turn knob (B) clockwise several times.

4.Tighten set screw down in the lower slot.

5.Test park brake.

Service Steering & Brakes - 40